Cleanfilm is an environmentally-friendly latex based solution which allows you to really reach every single little detail. Simply apply, wait for 24 – 48 hours and peel away. The film will solidify and draw out all of the dirt in the process, satisfaction will be guaranteed when pulling it away.
A thin layer of latex paste is applied to a surface by brush or spray. It’s then left for 24 to 48 hours during which time it absorbs dirt, stains and pollution. The latex takes on rubber-like properties and can then be peeled off the surface and disposed of in normal landfill sites.
This product doesn’t use water and there’s no risk of leaving salts or other chemical residues. There are no chemical after effects to the substrate.
Cleanfilm works by absorbing dirt from the surface, so once the paste has dried out it will not absorb anymore, you may find by leaving it on longer the paste may be more difficult to remove; if you find the surface is damp once the Cleanfilm has been peeled away, simply use a clean damp sponge to wipe it away. If you need a deep clean, we would recommend applying the product with a brush and really pushing it into the surface. A second application can be applied if necessary.
All Stonehealth approved aggregate contains less than 1% quartz with no other form of crystalline silica. It is completely safe for the environment & non-toxic.
